Call NowFree Estimate

200 Amp Service & Panel Upgrade in Port au Port, NL

200 Amp Service & Panel Upgrade for Port au Port homeowners. The Port au Port Peninsula is Newfoundland's French Ancestral region, running from Port au Port East out around to Cape St. George. We cover the whole peninsula loop.

5★Local ReviewsCode 1 ElectriciansTakeCharge ApprovedAll of NL
5★
300+
Code 1
All of NL

Why Port au Port Homes Need Quality 200 Amp Service & Panel Upgrade

The peninsula is exposed on three sides. Wind and salt air are constant, particularly out toward Cape St. George and along the West Bay shore. Many communities are a fair drive from the nearest large town, so homeowners here have historically had a hard time getting a contractor to show up at all.

Most older Newfoundland homes were built on 100 amp electrical service, which is fine for the appliances of the 1970s and 80s but tight for modern loads. A heat pump install, an EV charger, an electric range, or a hot tub can quickly push you past what your panel can handle. We do 200 amp service upgrades across NL — pulling the permit, doing the wiring, coordinating the utility shutoff, and handling the inspection.

5

Customer Rating

300+

Projects Done

Code 1

Electricians

$22K

Max Rebate

What Our 200 Amp Service & Panel Upgrade Includes

200 Amp Service & Panel Upgrade for Port au Port homes — full scope

Full 100 amp to 200 amp service upgrade
New panel, new meter base, new service entrance
Code 1 permits and inspections handled
Utility coordination for power shutoff
Often a prerequisite for heat pump installs and EV chargers
Workmanship warranty included

Need 200 Amp Service & Panel Upgrade in Port au Port?

Call (709) 634-0623 or fill out our contact form — 2 hours from corner brook

200 Amp Service & Panel Upgrade FAQ for Port au Port

It's an upgrade from your existing electrical service — usually 100 amp on older NL homes — to 200 amps, which gives you the headroom to run modern loads like heat pumps, EV chargers, and electric ranges. You probably need one if you're installing a heat pump and your panel is already at or near its limit.