Call NowFree Estimate

200 Amp Service & Panel Upgrade in Humber Arm South, NL

200 Amp Service & Panel Upgrade for Humber Arm South homeowners. Humber Arm South runs along the south shore of the Bay of Islands — Benoit's Cove, Frenchmans Cove, Halfway Point, and John's Beach — and continues out to York Harbour and Lark Harbour.

5★Local ReviewsCode 1 ElectriciansTakeCharge ApprovedAll of NL
5★
300+
Code 1
All of NL

Why Humber Arm South Homes Need Quality 200 Amp Service & Panel Upgrade

The south shore road is narrow and the communities are strung along the water, so homes here get direct exposure off the bay. Winter wind coming down the arm is significant, and older homes along the shore are frequently still on oil.

Most older Newfoundland homes were built on 100 amp electrical service, which is fine for the appliances of the 1970s and 80s but tight for modern loads. A heat pump install, an EV charger, an electric range, or a hot tub can quickly push you past what your panel can handle. We do 200 amp service upgrades across NL — pulling the permit, doing the wiring, coordinating the utility shutoff, and handling the inspection.

5

Customer Rating

300+

Projects Done

Code 1

Electricians

$22K

Max Rebate

What Our 200 Amp Service & Panel Upgrade Includes

200 Amp Service & Panel Upgrade for Humber Arm South homes — full scope

Full 100 amp to 200 amp service upgrade
New panel, new meter base, new service entrance
Code 1 permits and inspections handled
Utility coordination for power shutoff
Often a prerequisite for heat pump installs and EV chargers
Workmanship warranty included

Need 200 Amp Service & Panel Upgrade in Humber Arm South?

Call (709) 634-0623 or fill out our contact form — 30 minutes from corner brook

200 Amp Service & Panel Upgrade FAQ for Humber Arm South

It's an upgrade from your existing electrical service — usually 100 amp on older NL homes — to 200 amps, which gives you the headroom to run modern loads like heat pumps, EV chargers, and electric ranges. You probably need one if you're installing a heat pump and your panel is already at or near its limit.